Services & Pricing

Clear pricing for KitchenAid® stand mixer repair in the Triangle, NC. 

Every repair starts with a full regrease and inspection so we can diagnose the mixer correctly. Many common problems — grinding, slow speeds, leaking grease, or sluggish performance — are fixed with that service alone.

Our services

Regrease & Detailing — $129

The regular care service! 

  • Full inspection and diagnostics
  • Complete disassembly of gears
  • Thorough detailing (done to every part, screws included)
  • New Grease (6 oz. Phillips 66 Food Machinery NLGI 2)
  • New gasket
  • Reassembly and final tuning
  • Speed Calibration (60 rpm at Stir and 180 rpm at speed 6)

(Plus cost of any additional parts if needed)

Regrease + Bearings — $159

All what's included in the Regrease and Deep Clean service

+ Front armature bearing replacement
+ Rear assembly bearing replacement

Note: Most common mixer issues (grinding noise, slow speeds, leaking grease, or sluggish performance) can be fully resolved with the Regrease service and a bearing replacement

(Plus cost of any additional parts if needed)

    Inspection  — $50 (credited afterwards) + parts

    Inspection of the mixer, internal check and quote to provide the clearest mixer's condition, needs and costs. 

    Inspection cost credited to final bill, should the job be conducted by ourselves. 

    Note: Most mixers require a full re-grease before any underlying issues can be properly diagnosed. This is often done during the initial service.

    Small Hardware & Parts

    While servicing your mixer, some parts may need to be replaced. Luckily, spare parts cost isn't too expensive. Cost ranges: 

    • Gears, bearings, speed parts: $15 – $30+ each
    • Nuts, screws, bolts, pins, washers, feet, etc.: $5 – $10 each

    Prices subject to change without notice based on parts supply. 

    Separate Services

    We provide other services on a regular basis, based on KitchenAid® known issues. 
    These modifications are not mandatory but highly recommended to ensure your mixer the best operational conditions. 

    Beater adjustment (Included with Regrease & Deep Clean) $20
    Tilt pin replacement $20
    Speed control board replacement (Pro 600 model) $50
    Speed Calibration $20
    Increase Mixer stability by installing Larger mixer feet $20
    Improve Attachments sturdiness by installing spring and split washer to attachment shaft $10
    Secure the planetary from falling down (Pro-600/5) $40
    Transmission housing-metal (Pro-600/5, on regrease) $80
    Replacing the plastic melting speed control rod with a Metal rod (recent models) $35

    Improve your way to bake!

    Available accessories to elevate your mixing experience

    Stability and Sturdiness

    Large foot pads – $20
    (Tilt heads only)

    Organization

    Cord Roller – $10

    Cleanliness

    Funnel Pouring Chute – $15

    Important Notes

    All prices are for standard KitchenAid® stand mixers (1978- current tilt-head and bowl-lift models). Prices for vintage mixer (before 1978) may be different due to complexity and parts limited supply.

    Vintage, commercial, or heavily damaged mixers may require custom quoting.

    30-Day Mechanical Warranty on all new parts installed. Refer to Q&A Warranty

    We do not accept shipping or ship anything. We service local residents, drop off and pick up available only. This ensures consistent services, lower prices on repairs and personable professional experience.

    Cash Only — Payment due at time of pickup.

    Once you have been notified of completed services,  If payment isn’t received after 60 days, we reserve the right to sell your mixer to recoup costs.